AGA marvel M18AF Mode D'emploi page 19

CUSTOM GRILLE FACIA AND DOOR PANELS
68 ⁄ "
3
16
(173.2cm)
MODEL "D"
M18AF-WP 16 ⁄ " (41.5cm)
5
16
M18AF-SP 16 ⁄ " (41.5cm)
5
16
M24AF-WP 22 ⁄ " (56.7cm)
5
16
M24AF-SP 22 ⁄ " (56.7cm)
5
16
M30AF-WP 28 ⁄ " (71.9cm)
5
16
M30AF-SP 28 ⁄ " (71.9cm)
5
16
M36AF-WP 34 ⁄ " (87.2cm)
5
16
M36AF-SP 34 ⁄ " (87.2cm)
5
16
Table D
"D"
Figure 27
Door Gasket-
Screw-
Solid door-
Door panel-
CAUTION
!
Door panels MUST NOT exceed 50 lbs. Do NOT use glass,
mirrors, granite or similar heavy materials for panels. Pan-
els weighing more than 50 lbs. may cause product damage.
We recommend that the door load (panel and food) NOT
exceed 90 lbs.
Step 2: Size the Overlay Panel
Cut the custom overlay panel to the dimensions shown in
Figure 27 and Table D.
This is also a convenient time to locate and drill the holes
for your handle. Most often the handle is to match that of
the surrounding cabinetry. If your handle attaches from the
back-side of the custom panel, locate the mounting holes
while the panel is attached to the door and cabinet. After
the panel is removed from the door, drill the mounting holes
from the front, to the recommended diameter of the handle
manufacturer. Counter bore the back-side of the panel so
the screw heads do not interfere with the surface of the
door.
19
Figure 28