Hatco SRB Manuel D'installation page 12

MAiNteNANCe
Replacing the heat Lamps
WARNING
Use only Genuine hatco Replacement Parts when service
is required. Failure to use Genuine hatco Replacement
Parts will void all warranties and may subject operators of
the equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine hatco Replacement Parts
are specified to operate safely in the environments in which
they are used. Some aftermarket or generic replacement
parts do not have the characteristics that will allow them
to operate safely in hatco equipment.
Use only low pressure halogen light/heat lamps that meet
or exceed National Sanitation Foundation (NSF) standards
and are specifically designed for food holding areas.
NOTE: Hatco halogen heat lamps meet NSF standards for food
holding and display areas.
NOTE: The glass shield inside the lamp cover is loose and will
drop down with the lamp cover. Make sure to support
the lamp cover with one hand during removal of the
screws.
NOTICE
Do not touch halogen heat lamps with bare skin. Oils from
the skin will cause premature failure of the lamps.
Lamp
Holder
Lamp
Lamp
Cover
Standard Wattage
high Wattage
Screw