Resetting The Adjustments; Technical Features; Preset And User Modes; Power Saving Function - Sony Trinitrin CPD-G500 Mode D'emploi

Resetting the adjustments

This monitor has the following three reset methods. Use the
RESET button to reset the adjustments.
RESET
Resetting a single adjustment item
Use the control button to select the adjustment item you want to
reset, and press the RESET button.
Resetting all of the adjustment data for the
current input signal
Press the RESET button when no menu is displayed on the screen.
Note that the following items are not reset by this method:
• on-screen menu language (page 8)
• adjustment mode in the COLOR menu (EASY, EXPERT,
sRGB) (page 13)
• on-screen menu position (page 15)
• control lock (page 15)
Resetting all of the adjustment data for all input
signals
Press and hold the RESET button for more than two seconds.
Note
The RESET button does not function when
is set to ON.
16

Technical Features

Preset and user modes

When the monitor receives an input signal, it automatically
matches the signal to one of the factory preset modes stored in the
monitor's memory to provide a high quality picture at the center of
the screen. (See Appendix for a list of the factory preset modes.)
For input signals that do not match one of the factory preset modes,
the digital Multiscan technology of this monitor ensures that a
clear picture appears on the screen for any timing in the monitor's
frequency range (horizontal: 30 – 121 kHz, vertical: 48 – 160 Hz).
If the picture is adjusted, the adjustment data is stored as a user
mode and automatically recalled whenever the same input signal
is received.
Note for Windows users
For Windows users, check your video board manual or the utility
program which comes with your graphic board and select the
highest available refresh rate to maximize monitor performance.

Power saving function

This monitor meets the power-saving guidelines set by VESA,
E
computer or video graphics board that is DPMS (Display Power
Management Signaling) compliant, the monitor will automatically
reduce power consumption in three stages as shown below.
(CONTROL LOCK)
* "Sleep" and "deep sleep" are power saving modes defined by the
** When your computer enters in a power saving mode, the input signal
S
NERGY TAR, and NUTEK. If the monitor is connected to a
Power mode Power consumption
≤ 145 W
normal
operation
≤ 100 W
1 standby
≤ 15 W
2 suspend
(sleep)*
3 active off** Approx. 1 W
(deep sleep)*
power off 0 W
Environmental Protection Agency.
is cut and NO INPUT SIGNAL appears on the screen. After a few
seconds, the monitor enters power saving mode.
1 (power)
indicator
green
green and orange
alternate
green and orange
alternate
orange
off