Kaiser Fototechnik SmartCluster Vario 8 Mode D'emploi page 13

light, there have to be four clips on
one long side of the light and two clips
on the other long side. The grid at-
tachment has corresponding notches
for the clips of the diffusor screen.
Switch off the light when not in use
by pressing the ON/OFF button (12)
for approx. 1.5 seconds.
An electronically stabilized light output
keeps the set brightness constant for
a longer period of time when the sup-
ply voltage goes down. If the light re-
duces brightness to 10 % by itself,
switch off the light by pressing the
ON/OFF button (12) and recharge it.
You may operate the light for some
minutes with reduced brightness, but
if not switched off manually, the light
will power off automatically to prevent
deep discharge of the battery.
7. Maintenance and care
If you do not use the light for a longer
period of time, the battery should be
recharged every 6 months and the light
should kept in a dry, cool place (15 -
18° C).
Make sure that the front screen is free
of stains and dirt. If necessary remove
these before operation.
Clean the light with a soft dry cloth. On
no account use petrol or other cleaning
agents and solvents.
8. Specifications
Light source: 104 SMD LEDs
Color temperature: approx. 3200 -
6500 Kelvin
Panel size: 12.8 x 5.8 cm
(5 x 2.3 in.)
Operating voltage: 3.7 V
Illumination: 300 lux (at 1 m /
3.3 ft.)
Angle of radiation: 110°
Operating time: approx. 1 hour at
full power, 3.5
hours if dimmed
down
Lithium-ion battery: 3.7 V, 2500 mAh
Dimensions
(WxHxD): 143 x 73 x 12 mm
(5.6 x 2.9 x 0.5 in.)
Weight: 185 g (6.5 oz.)
9. Accessories
3272 Hand grip
6040 Table stand with accessory
shoe
15