SEDONA SDC-S101 Mode D'emploi page 13

• RAW Mode Use Only
The RAW mode operates in a way such that when the heat sensor reaches the set temperature,
heating assembly will cut off to sustain a drying environment lower than indicated temperature
to protect from overheating your food.
1. Set the Sedona Combo to RAW mode by pressing the MODE button two times. (A GREEN light
to the lower right of the MODE button will indicate that the unit is set on RAW mode.)
2. Press the F°/C° button to choose Fahrenheit or Celsius.
3. Press the SET button to set your desired temperature using the UP/DOWN 10 or 1 buttons.
4. Press the SET button again to set your desired time using the UP/DOWN 10 or 1 buttons.
5. Press the SET button again to finalize your settings. The numbers will stop flashing.
6. Press the START/PAUSE button to begin operation.
7. The dehydrator will beep and automatically switch to stand-by mode after the set time has
expired.
8. Turn the main switch OFF after dehydration has finished.
NOTE:
• dehydrator is designed to evenly distribute warm air from the rear to the front of the unit.
Depending on the climate and temperature of the air flowing into the unit from the rear,
there may be a slight difference in temperature between the trays and inside the drying
compartment.
• Because heat rises naturally, it is normal for the top trays to be exposed to more heat than the
trays in the center or on the bottom. For best results, rotate the trays periodically.
EN
13