Trouble Shooting - Parkside PLSA 40-Li C2 Instructions D'origine

GB IE

Trouble shooting

Problem
Device does not
start
Device works
with interrup-
tions
Weak or no
suction/blow-
ing power
Impeller does
not move
40
Possible cause
Battery discharged (5)
Battery (5) not inserted
On/off switch (4) is defective
Defective motor
Suction pipes (16) and collection
bag (15) or blowpipe (9) and
protective cover (7) not installed
correctly
Internal loose contact
On/off switch (4) is defective
Low battery power
Collection bag (15) is full
Collection bag (15) is dirty
Impeller or blowpipe (9) and/or
suction pipe (16) is clogged or
blocked
Foreign body blocking the impeller
Corrective action
Charge the battery
(see "Charging the battery")
Insert the battery (see "Inserting/
removing the battery")
Repair by Service Centre
See the section on "Initial use"
Repair by Customer Care
Charge battery (5)
(see "Charging the battery")
Empty collection bag
Clean collection bag
see chapter "Removing obstruc-
tions and blockages"
Remove the blockage (see "Remov-
ing obstructions and blockages")