Publicité
Les langues disponibles
Les langues disponibles
J: When the S VE
function is activated, the
heater will automatically
switch on or off in order
to remain within a
specified temperature
range.
K: When the FUEL
indicator has appeard,
the information display
will show the number of
minutes of fuel left in
the tank.
L:
blinking
indicator light is a sign
that you need extra
ventilation.
M
Fuel filter
N
J
THE C ORREC T USE OF 'SAVE'
The 'SAVE' function allows you to limit the temperature. When this function is
activated, the heater will automatically switch off, when the room temperature
exceeds the set temperature by 3°C. Subsequently, when the room temperature has
dropped again to the set temperature, the heater will automatically switch on again.
Activate the 'SAVE' setting by pressing the appropriate
information display (Fig. J). Switch off the function by pressing the SAVE key once again.
Without the 'SAVE' setting your heater will maintain the set temperature by
approximation as well, by adjusting its heating capacity. 'SAVE' is an economy
setting, which you can use when, for instance, you are not present in the room
or to keep it frost-free.
K
THE 'FUEL' INDIC ATOR
When the FUEL indicator appears, it means that there is only fuel left for 10 more
minutes. The count-down of the remaining heating time can be seen in the
information display ¹ (Fig. K). Now you have two options:
you remove the fuel tank and refill it outside the living room (section B) or
you push the button EXTENSION
heating time will extend to 90 minutes. The heater will automatically switch
back to its lowest position. In the display the number 90 will appear, which
will decline to 10. At the arrival of 10, you will hear an alarm signal every two
minutes, warning you to refill the removable tank. If you do not react, the
heater will extinguish by itself. The heater will also sound a warning signal,
when it switches off. The fuel indicator will blink, while four lines (--:--)
are blinking in the information display. You can stop this by pressing the
button
once more.
Once the heater has used up all its fuel and extinguished, it will take some time,
after the refill, before the heater is completely ready for use again.
L
THE 'VENT' INDIC ATOR
When there is insufficient ventilation in the room, an intermittent buzzer will be
heard (approximately once each 30 seconds) and the VENT indicator
blinking. When this signal is given, ensure that the ventilation of the room is
improved (e.g. by opening a door or window a little more), to avoid that the heater
shuts off. When the ventilation of the room is improved, the VENT indicator and
buzzer will be deactivated. When there is still insufficient ventilation, the heater
shuts off automatically. When this occurs, e- 1 1 is displayed and the
blinking and VENT indicator (
(e.g. by opening a door or window a little more), the heater can be ignited by
pushing
again.
M
MAINTENANC E
Switch off the heater and let it cool down, before you start any maintenance
work. Also disconnect the plug from the mains. Your Zibro needs hardly any
maintenance. It is, however, important that you clean the air filter
filter
with a vacuum cleaner and the grid
weekly basis. Remove the air filter cap occasionally (Fig. M) and clean it with soapy
water. Prior to reinstallation, make sure that the air filter cap has fully dried.
Regularly inspect the fuel filter as well:
1
Remove the removable tank
(Fig. N). Some drops may leak from the filter; keep a cloth at hand.
key.
. By pushing this button, the remaining
) is lit. After improving the ventilation of the room
with a damp cloth, both on a
from the heater and remove the fuel filter
will display on the
will be
indicator is
and the vent
59
Publicité
