Maintenance; Problems - Causes - Solutions - Volpi V-BLACK SMART 19SME Mode D'emploi

5.6 CHANGE OF LIQUID IN THE TANK
In case a change of the liquid inside the tank is necessary, follow the instructions given in point 5.6 and after that, the
instructions in point 5.2.
6

MAINTENANCE

6.1 INTRODUCTION
A correct use of the sprayer and a regular maintenance are necessary to keep the sprayer in the best working, efficacy and
safety conditions.
Use exclusively original spare-parts.
6.2 BATTERY RECHARGE
The sprayer powered by a sealed storage battery, rechargeable through USB cable (not included) to be connected to the
Micro USB port which is placed on the basis of the sprayer, next to the led indicators of the charge level.
The Micro USB port is secured by a proper cover.
WARNING: During the recharge operations, follow safe working procedures and carefully observe the general safety rules.
In order to recharge the battery, follow these instructions:
•
Turn off the general switch
•
Open the cover of the Micro USB port.
•
Connect the USB cable of the power supply (not included) to the Micro USB port placed at the basis of the sprayer.
•
Once the recharge process has started all the led lights flash sequentially. When the 3 led are all turned on, the recharge
is almost complete.
•
To recharge the battery completely, you need 3-4 hours.
•
Once the recharge is completed, place the cover on the Micro USB port again.
•
During long periods of inactivity, check that the general switch is off.
The battery life mostly depends on the observance of some important rules:
•
Do not create a short-circuit.
•
Do not discharge it excessively: when the battery is almost discharged, charge it immediately.
•
Promptly recharge it with the general on/off switch turned off and respecting the necessary time of charging.
•
Do not turn on the sprayer during the charging phases.
•
Always store the sprayer with the general switch off.
•
After the complete recharge keep the sprayer between 5 and 40° C.
•
In case of long stocking or non-use, recharge the battery every four months.
7 PROBLEMS – CAUSES – SOLUTIONS
When turning on the switch of
the sprayer, no water is coming
out
When turning on the switch of
the sprayer, a little water is
coming out.
Battery working time is not as
expected
________________________________________________________________________________________________________________________________________________________________________________________________________
DAVIDE E LUIGI VOLPI S.p.A. - Via San Rocco,10 - 46040 CASALROMANO (MN) - ITALY
Davide e Luigi Volpi S.p.A.
Via San Rocco,10 – 46040 Casalromano (MN) – Italy
Tel. +39 0376.76009 - 76012 Fax. +39 0376.76408
E-mail: commerciale@volpioriginale.it
PROBLEMS
Motor does not work
Motor works
Lower working time
No endurance
www.volpioriginale.it
– export@volpioriginale.it
POSSIBLE CAUSES
Low battery
Blocked sprayer
Broken cable
Engine failure
Clogged nozzle
Clogged sprayer filter
Clogged handle filter
Defective sprayer
Dirty sprayer filter
Defective sprayer
Dirty nozzle
Battery not fully charged
Broken cable
YLB19SME_1 Libretto d'uso V_BLACK SMART
SOLUTIONS
Recharge
Contact the service centre
Contact the service centre
Contact the service centre
Clean
Clean
Contact the service centre
Clean
Contact the service centre
Clean
Recharge the battery
Contact the service centre
pag. 16 di 40