Start Charging - AEG LM 1.5 Mode D'emploi

Note:
the black (-) clamp can also be connected to the
vehicle chassis (please refer to the auto maker's in-
structions!). Be sure both clamps have good contact
and are securely seated.
4. plug the charger plug into a 230V power socket.
if the charger is connected correctly, the "power"
Led (12) will light up. in this mode the charger will
automatically reset to the default settings.
if the battery is recognised to be defective or con-
nected with the poles reversed, the "error" Led (9)
will light up. in this case, unplug the charger and
check the battery and the correct connection (also
see "troubleshooting").

Start charging

1. repeatedly press the seLeCt button (1) to select the desired charging mode, 6 V
or 12 V. the Led will indicate your selection.
Note:
if an incorrect charging mode was selected, the "error" Led (9) will light up. in this
case unplug the charger, wait briefly, and plug in again.
2. the charging process will start automatically. the "Charge" Led (11) will light
up throughout the charging process.
3. the battery is fully charged when the "Full" Led (10) lights up and the "Charge"
Led (11) goes out.
Note:
once the battery is fully charged, the charger will switch to trickle charge to main-
tain the charging status and protect the battery from overcharging.
Ld 5.0 and Ld 7.0 Microprocessor Charger only:
▪
the display will show 100 and the Led "%" will light up.
▪
Use the dispLaY (2) button to switch the display during charging (see "product
overview").
GB
35
SELECT
3,5 A 7,5 A
LD 8.7
DISPLAY
Power
Charge
Full
Error