Publicité
SERVED AS A DO-IT-YOURSELF TOOL SHOULD NOT
BE USED BY PROFESSIONALS FOR EXTENDED USES
HAVE THE POWER TOOL REPAIRED BY QUALIFIED
PEOPLE. ANY POWER TOOL THAT CANNOT BE
CONTROLLED WITH THE SWITCH IS DANGEROUS
AND MUST BE REPAIRED BY A QUALIFIED PERSON.
DISCONNECT THE POWER TOOL FROM THE POWER
SOURCE BEFORE ANY INTERVENTION. DISCONNECT
THE PLUG FROM THE POWER SOURCE AND/OR THE
BATTERY PACK BEFORE MAKING ANY ADJUSTMENT,
CHANGING ACCESSORIES, STORING THE POWER
TOOL, AND MAINTAINING THE POWER TOOL.
STORE POWER TOOLS IN A SAFE PLACE. STORE
IDLE POWER TOOLS IN A DRY AND A CLEAN PLACE,
OUT OF THE REACH OF CHILDREN.
MAINTAIN PREVENTIVELY THE POWER TOOL.
MAIN SAFETY INSTRUCTIONS FOR IMPACT DRILL
WEAR SAFETY PROTECTION. ALWAYS WEAR SAFETY
GOOGLES OR EYE PROTECTION WHEN USING THE
IMPACT DRILL TO PREVENT ANY PROJECTION THAT
MAY DAMAGE YOUR EYES.
DO NOT WRAP THE CORD AROUND YOUR WRIST,
ARM OR WAIST TO AVOID BEING DESTABILIZED.
DO NOT GRASP THE TOOL OR PLACE YOUR HANDS
TOO CLOSE TO THE SPINNING CHUCK OR DRILL BIT.
YOUR HAND MAY RUN THE RISK OF BEING INJURED.
POSITION YOURSELF TO AVOID BEING CAUGHT
BETWEEN THE TOOL OR SIDE HANDLE AND WALLS.
SHOULD THE BIT BECOME BOUND OR JAMMED IN
THE WORK, THE REACTION TORQUE OF THE TOOL
COULD CRUSH YOUR HAND OR LEG.
WHEN INSTALLING AN ACCESSORY, INSERT THE
SHANK OF THE ACCESSORY DEEP ENOUGH IN THE
Ref.:647061; 647063
-
INSPECT REGULARLY THE MOUNTING PARTS;
CHECK IF ALL THE LOOSE SCREWS ARE
PROPERLY TIGHTENED.
-
REGREASE THE POWER TOOL WITH GEARS
WITH SPECIAL LUBRICANT AT EVERY BRUSH
CHANGE.
-
AFTER REGULAR EXAMINATION OF THE STATE
OF THE BRUSHES AND COMMUTATOR, SEE
WHETHER
THESE
CHANGED.
-
CLEAN YOUR POWER TOOLS BODY USING A
CLEANING CLOTH LIGHTLY WET WITH A MIXED
SOLUTION OF WATER AND SOAP.
JAWS OF THE CHUCK TO PREVENT THE RISK OF
LOSING THE CONTROL OF YOUR IMPACT DRILL.
AS DRILL BITS MAY BE HOT AFTER PROLONGED USE,
WHEN REMOVING THE BIT FROM THE TOOL, AVOID
ANY CONTACT WITH YOUR SKIN, AND USE PROPER
PROTECTIVE GLOVES WHEN GRASPING THE BIT OR
OTHER ACCESSORIES.
NEVER
USE
EXCESSIVE
PRESSURE CAN REDUCE THE SPEED OF YOUR DRILL
AND REDUCE ITS EFFICIENCY. THIS CAN RESULT IN
AN OVERLOAD WHICH CAN CAUSE DAMAGE TO THE
ELECTRIC MOTOR OF YOUR IMPACT DRILL.
10
PARTS
NEED
TO
BE
FORCE.
TOO
MUCH
Publicité
