Télécharger Imprimer la page

Zerowatt OZ 1 D Optima Mode D'emploi page 19

Publicité

DE
Befestigen Sie die gewellte
Bodenplatte wie in der
Abbildung dargestellt.
Den Zulaufschlauch an den
Wasserhahn anschließen.
Das Gerät muß an die
Wasserversorgung mit neuen
Schläuchen angeschlossen
werden.
Alte Schläuche dürfen nicht
wiederverwendet werden.
ACHTUNG:
WASSERHAHN NOCH NICHT
ÖFFNEN.
Die Waschmaschine an die
Wand rücken, darauf achten,
daß dabei der Schlauch nicht
verkrümmt oder eingeengt
wird.
Ablaufschlauch am
Wannenrand
befestigen, oder an einem
festen Abfluß von mindestens
50 cm Höhe anbringen, dessen
Durchmesser größer ist als der
des
Waschmaschinenschlauchs.
Falls erforderlich den
mitgelieferten starren
Rohrbogen benutzen.
CZ
Upevnëte ke dnu praöky
püiloïenÿ protihlukovÿ ätít z
vlnitého materiálu podle
obrázku.
Hadici püívodu vody
püípevnëte k vodovodnímu
kohoutu koncem s pojistnÿm
ventilem (Water stop system).
Spotüebiö musí bÿt püipojen k
püívodu vody novou hadicí,
která je souöástí vÿbavy
spotüebiöe. Staré hadice
nesmëjí bÿt znovu pouïívány.
D D Å Å L L E E Ï Ï I I T T É É : :
V V T T É É T T O O F F Á Á Z Z I I N N E E P P O O U U Ä Ä T T Ë Ë J J T T E E
V V O O D D U U . .
Opüete konec odtokové
hadice o vanu a dbejte na
to, aby na hadici nevznikly
zlomy nebo ohnutí. Odtoková
hadice má bÿt umístëna ve
vÿäce min. 50 cm.
Je lepäí pouïijete-li pevného
odpadu o vëtäím pråmëru,
neï je pråmër odtokové
hadice, tím umoïníte
pråchod vzduchu.
Pokud je potüeba, pouïijte
pevnÿ U-drïák k upevnëní
hadice.
Püípadné prodlouïení
odtokové hadice måïe zavinit
poruchy v chodu odtokového
öerpadla a filtru, zejména v
püípadë, je-li deläí neï 1 m.
EN
Fix the sheet of corrugated
material on the bottom as
shown in picture.
Connect the fill hose
to the tap.
The appliance must be
connected to the water
mains using new hose-sets.
The old hose-sets should not
be reused.
IMPORTANT:
DO NOT TURN THE TAP
ON AT THIS TIME.
Position the washing
machine next to the wall.
Hook the outlet tube to the
edge of the bath tub,
paying attention that there
are no bends or
contractions along the tube.
It is better to connect the
discharge hose to a fixed
outlet of a diameter greater
than that of the outlet tube
and at a height of min. 50
cm. If is necessary to use the
plastic sleeve supplied.
min 4 cm
+2,6 mt max
min 50 cm
max 85 cm
19

Publicité

loading

Produits Connexes pour Zerowatt OZ 1 D Optima

Ce manuel est également adapté pour:

Oz 1061d/l-s optima