Domo PIET HUYSENTRUYT DO447BL Mode D'emploi page 31

www.domo-elektro.be
3. Place the lid onto the jar.
4. Plug in the blender.
5. Turn the speed knob to the required speed.
1 - low: for light use with liquids.
2 - high: for a more solid consistency - for mixing liquids and solid foods.
P - pulse: for crusing ice, for mixing solid ingredients or thick liquids and for
short, powerful blending
6. For quick and accurate blending, turn the speed knob to the P position and hold
for a few seconds. When you release the knob, it will automatically reset itself to
the 0 position. You can do this a few times in a row, until the desired consistency
has been reached.
7. If you want to add liquid ingredients while you are blending, pour these
ingredients in the jar through the fill opening in the lid.
8. When crushing ice or blending hard foods, keep 1 hand firmly onto the lid.
9. Turn off the blender by setting the speed knob to 0.
10. Remove the jar from the motor unit.
11. Unplug the blender after use.
Caution: For each use, the consecutive operation time should not exceed 3
minutes. Between two continuous cycles at least 1 minute resting time should be
maintained. The appliance needs to cool down sufficiently before starting the next
blending cycle.
IMPORTANT TIPS
• When blending solid foods with liquids, first pour the liquid into the jar and only
then add the solid foods. Start with a limited amount of liquid and gradually add
more liquid while blending through the fill opening in the lid.
• Be careful when blending warm liquids.
• Cut solid foods into pieces first and start with blending a small amount. Gradually
add more pieces.
CLEANING AND MAINTENANCE
1. Pour some warm soapy water into the jar and turn the speed knob for a few
seconds to the P position. Empty the jar.
2. Unplug the blender before continuing with cleaning.
3. Always clean the blender immediately after us for easy cleaning. Do not let food
31
DO447BL