Startup / Operation - BOMANN DU 652.1 IX Mode D'emploi

For exhaust mode:
Hereupon a flexible exhaust hose
(included in delivery) with 150 mm inner diameter
must be attached [Fig. 2a]. Secure the hose with the
cable tie.
 Hang up the housing. Check the secure hold and
the horizontal position [Fig. 3].
 Secure the housing with the screws
2x ST4*30mm through the housing [Fig. 4].
 Fasten the outer (lower) shaft with the bracket
(03) using the 2x ST4*8mm self-tapping screws
[Fig. 5].
For exhaust mode:
Check the correct position of the
exhaust hose and connect it with the outlet opening.
 Put on the telescoped shaft unit and tighten the
middle bracket (03) with the screws 2x
ST4*40mm [Fig. 6].
 Pull up the inner shaft and fix the shaft cover lat-
erally to the shaft closure bracket using self-
tapping screws 2x ST4*8mm [Fig. 7].
Installing the activated carbon filter for recirculation
mode
 Remove the aluminum grease filter(s) (see
"Cleaning the aluminum grease filter"
 Place the carbon filter onto the air intake of the
extraction duct. Make sure that the mounting pins
on the extraction duct engage the mounting slots
of the carbon filter.
 Reinstall the aluminum grease filter(s).
).
Turn the filter clockwise
until it clicks into place.
Electrical connection
WARNING:
 The installation to the mains supply must conform
to the local standards and regulations.
 Improper connection may cause to an electric
shock!
 Do not modify the appliance plug. If the plug does
not fit properly to the outlet, let install a proper
outlet by an authorized specialist.
 The accessibility of the power plug must be en-
sured to disconnect the appliance from the power
supply in case of emergency.
 Ensure that your mains power corresponds with
the specifications of the appliance. The specifica-
tions are printed on the rating label.
 Connect the mains cable to a properly installed
and earthed wall outlet.
 If the plug after installation is not accessible, a
corresponding disconnect device must be availa-
ble to meet the relevant safety regulations.

Startup / Operation

The cooker hood is operated via two slide switches.
The lighting and the power levels can be switched on
and off with the corresponding switches.
Power level
0 off I low
Lighting
0 lighting off
Settings
I Power level:
Suitable for cooking on a low flame and for dishes
which produce no or little steam to circulate the air
around the kitchen.
II Power level:
Suitable for normal cooking.
43
II medium III high
I lighting on