Philips GC7600 Série Mode D'emploi page 10

ENGLISH
10
Problem
The appliance
does not produce
any steam.
The appliance
produces a loud
pumping sound.
The appliance has
switched off.
The iron leaves a
shine or an imprint
on the garment.
The ironing board
cover becomes
wet.
The iron produces
too much steam.
Possible cause
There is not enough water in the
water tank.
You have not pressed the steam
trigger.
The water tank is empty.
The safety auto-off function is
activated automatically when the
steam generator has not been
used for more than 5 minutes.
The surface to be ironed was
uneven, for instance because you
were ironing over a seam or a
fold in the garment.
Steam has condensed on the
ironing board cover after a long
ironing session.
You may have an ironing board
that is not designed to cope with
the high steam rate of the steam
generator.
The default setting of the iron is
the OptimalTemp setting. In this
setting, the iron provides a high
steam output.
This iron has been approved by The Woolmark Company Pty Ltd for
the ironing of wool only products provided that the garments are ironed
according to the instructions on the garment label and those issued by the
manufacturer of this iron. R1303. In United Kingdom, Eire, HongKong and
India, the Woolmark trademark is a Certification trademark.
Solution
Fill the water tank beyond the MIN indication.
Press and hold the steam trigger until steam
comes out. It may take up to 30 seconds until
steam comes out.
Press the steam trigger and keep it pressed
when you iron.
Refill the water tank with water and press the
steam trigger until the pumping sound stops
and steam comes out of the soleplate.
Press the on/off button to reactivate the
steam generator.
The Perfect Care is safe on all garments.
The shine or imprint is not permanent and
will come off if you wash the garment. Avoid
ironing over seams or folds or you can place
a cotton cloth over the area to be ironed to
avoid imprints.
Replace the ironing board cover if the foam
material has worn out. You can also add an
extra layer of felt material under the ironing
board cover to prevent condensation on the
ironing board.
Put an extra layer of felt material under the
ironing board cover to prevent condensation
on the ironing board.
Activate the ECO mode to iron with a lower
steam output. See section 'Energy saving' in
this user manual.