Component List; Assembly - Haussmann 68125118 Guide De L'utilisateur

6
1
2
3
4
5
!
Figure 2
Figure 3
Figure 4

COMPONENT LIST

13
12
11
10
9
8
7
Figure 1

ASSEMBLY

INSTALLING/REMOVING BLADE (Fig.2)
WARNIG: Always make sure the jig saw is unplugged from the power source
before attempting any assembly and/or adjustments.
This jig saw comes with a convenient tool-less quick release blade change
system. To install a blade, first you must lift the transparent guard upwards to gain
access to the quick release lever (A). With your thumb, pull the lever
counterclockwise to open the blade holding collet (B). With the blade teeth facing
forward, insert the blade (C) into the blade holding collet as far as it will go. Make
sure that the back edge of the blade sits against the roller guide (D). Release the
lever (A) and pull on the blade until the blade holding collet snaps and secures the
blade.
DUST CHUTE (Fig.3)
The supplied dust chute (A) gets installed to the back end of the jig saw body and
a vacuum can be adapted to the dust chute for efficient dust collection. To install
the dust chute, align dust chute pins with slots in dust chute opening, push dust
chute in and turn it clockwise to lock into place.
REPLACING LASER GUIDE/LED BATTERIES (Fig.4)
After extended use it will be neccessary to replace the two AAA batteries located
in the laser/LED housing (B) . If the batteries need to be replaced, follow these
instructions:
1) Remove the housing (B) by pushing upwards on the housing.
2) Remove used batteries (A) and replace with new AAA batteries.
3) Reposition the housing (B).
Figure 1 names the major components of the HAUSSMANN
jigsaw:
1. Rotary variable speed selector dial
2. Laser/LED light On/Off switch
3. Laser/LED light battery housing
4. Quick release blade change lever
5. Transparent guard
6. Trigger
7. Blower On/Off
8. Bevel locking cap screw
9. Base
10. Orbital settings lever
11. Dust Chute
12. Hex. key
13. Lock-on Button
19