Ups Setup - Best Power Axxium Pro 9910 Guide D'utilisation

UPS Setup

Each UPS consists of a 6-slot power enclosure containing power and
battery modules (varies by model). The enclosure, power and battery
modules, and casters are boxed and shipped individually.
Axxium Pro 9910 Installation Guide for IBM Applications
t
NOTE For operating conditions, BTU output, audible noise, and temporary storage of
batteries information refer to SECTION 1100, "Installation Planning" in the Axxium Pro
User / Installation Manual .
1. Use a fork lift or pallet jack to remove the pallets from the
delivery truck.
2. Use a pallet jack to place the pallets near the installation site.
3. Using two people, remove the power enclosure from the
package with the four lifting straps shipped with the enclosure
(see Figure 1).
NOTE Do not lift the power enclosure by the module shelves or other convenient
edges or panels.
Figure 1. Lifting the Power Enclosure
4. Verify that the site is able to support the size and weight of the
UPS when it is fully loaded with the battery and power modules
(see Table 4). The weight of the UPS on the caster cart is
concentrated on four 1.5" (38 mm) load levelers.
LTM-1341 A Uncontrolled Copy
S
Installation
3