Esoteric D-05 Manuel Du Propriétaire page 13

W-OUT (Word clock frequency)
Select the frequency of the word sync signal. The factory
setting is "44.1".
44.1 88.2
100 192
CH (Channel select)
When the i.LINK (AUDIO) terminal is connected to a digital
device, select the channels for this unit.
The factory setting is L/R.
L/R: front left and right channels
C/LFE: center channel and LFE (subwoofer)
LS/RS: surround left and right channels
< The icons of the selected channels light on the display.
i-RC (i.LINK remote function)
When multiple D-05 units are directly connected using i.LINK
cables and you use this function, the volume, muting and
dimmer of all D-05's in the chain can be controlled using only
one D-05.
Since this function is available as long as D-05's are
connected using i.LINK cables, you can use a different input
type other than i.LINK.
MASTR
SLAVE
When you set one D-05 as master and all other D-05's as
slaves, the volume, muting and dimmer of all D-05's in the
chain can be controlled using only the master unit.
This master-slave control has nothing to do with the channel
setting.
RC (Remote control)
In case of being used with Esoteric amplifier, you can set the
D-05 not to respond to the Esoteric remote control.
ENABLE
This setting enables the D-05 to be operated by the Esoteric
remote control.
DISABLE
This setting disenables the D-05 to be operated by the
Esoteric remote control.
176(176.4)
96 48
DISP (Display)
You can select whether the display normally displays the
volume or the sampling frequency.
VOL
Displays the value of the output level set using the VOLUME
buttons.
Fs
The sampling frequency is displayed.
During up converting, "U" will be displayed to the right of
the sampling frequency.
Display dimming
The display on the main unit can be dimmed to suit the
environment in which you listen to music.
FL Dimmer3:
Full brightness
FL Dimmer2:
Medium brightness
FL Dimmer1:
Minimum brightness
OFF:
The display and indicators are off.
< Note that the OFF setting is not memorized when the power
is turned off. When the unit is switched off with the display
off, and then turned on again, the display is reset to the
minimum brightness (FL Dimmer1).
< In OFF mode, when you press a button such as VOLUME, the
illuminations turn temporarily on.
(Normal display)
This exits the setup mode.
13