Safety �������������������������������������������������������� 33 Application Areas; General Safety Instructions ����������������������������������� 33 15.5 Data Table; Instructions, Standards And Regulations; Appliance Description - Stiebel Eltron DHM 3 Utilisation Et Installation

InstallatIon
safety
InstallatIon
7. safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1 general safety instructions
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
Material losses
!
Observe the max. permissible inlet temperature. Higher
temperatures may damage the appliance. You can limit
the inlet temperature by means of a central thermostatic
valve (see chapter "Appliance description / Accessories").
www.stiebel-eltron.com
7.2

instructions, standards and regulations

Note
Observe all applicable national and regional regulations
and instructions.
The specific electrical resistance of the water must not fall below
that stated on the type plate. In a linked water network, factor in
the lowest electrical resistance of the water (see chapter "Speci-
fication / Data table"). Your water supply utility will advise you of
the specific electrical water resistance or conductivity.
8.

appliance description

8.1

standard delivery

The following are delivered with the appliance:
- Sieve inside the cold water inlet
- Special aerator "SR"
- Connection hose 3/8, 500 mm long, with gaskets*
- Tee 3/8*
*for the connection as pressure-tested appliance
DHM | 33