Troubleshooting - Volfoni EDGE Universal VPEG-04010 Manuel D'utilisation

Dark Time :
Allows you to change the value of DarkTime
The slider allows you to adjust the value between -4000
microseconds (better luminosity) and 4000 microseconds
(better contrast). The value applied is inscribed above
the slider (0 in this example)
Moves Detection :
Enables or disables the Auto OFF feature when glasses
are not moving
Enabled: The glasses turn OFF automatically if no
movement is detected after 5 minutes (AUTO OFF
enabled).
Disabled: The glasses will stay on even if no motion is
detected. (AUTO OFF function disabled).
Advanced :
Delta Sync (μs) : Modify the sync offset (between -2000
and 2000 microseconds). Default = 0
12

7. TROUBLESHOOTING

PROBLEM
My glasses are not
displaying 3D.
The same problem
continue. My glasses
are still not displaying
3D.
The glasses are blinking
strongly
The glasses blink when I
turn them ON.
The EDGE™ Universal
glasses stay OFF.
SOLUTION
Check that your original
source is broadcasting 3D.
If yes, check if your 3D
system is correctly emitting
IR. Than make sure the
EDGE™ Universal glasses
are facing the IR emitter.
Please check if you have
the lastest software version
(part 5 of this user guide). If,
the problem persists please
ask the IR compatibility to
support@volfoni.com.
Check that there is no
other IR source within a
range of 30 meters around
the 3D system set-up.
When this phenomenon
occurs, it means that
the battery is low. Please
recharge the glasses.
Try recharging your glasses.
If the problem
persists, contact support@
volfoni.com
13