Bauknecht BAHTT 55 LM G Manuel D'utilisation Et D'entretien page 14

CARBON FILTER
It captures and neutralizes unwanted cooking odours.
Change the carbon filter every 4 months
Fitting or changing the carbon filter
1.
Pull out the steam deflector.
2.
Remove all the grease filters (refer to the section "grease filters").
3. Install the carbon filter covering the motor compartment.
Note: Proceed in reverse order to remove.
Proceed in reverse order to refit the grease filters in place.
MATERIAL SUPPLIED
Remove all the components from the packets. Check that all the components are included.
• Hood assembled with motor, bulbs and grease filters fitted.
• 1 instruction booklet
• 1 drilling template
• 1 cable clamp
• 1 screw (3.5 x 9.5)
• 1 power cable
• 2 brackets for adjusting the drawer's end stop
• 2 washers
• 2 screws (3.5 x 5)
• 4 spacers
• 2 torx adapters
• 4 screws (4.5 x 16)
• 6 round adhesive labels
• 2 half valves
Please note: Carbon filter not supplied.
INSTALLATION - PRELIMINARY ASSEMBLY INSTRUCTIONS
The hood is designed for installation and use in "Extractor version" or in "Filter version".
Extractor Version
Fumes are extracted and expelled to the outside through an exhaust pipe (not supplied) fixed to the hood exhaust pipe connector.
Depending on the exhaust pipe purchased, provide for suitable fixing to the exhaust pipe connector.
IMPORTANT: If already installed, remove the carbon filter/s.
Filter Version
Air is filtered through the carbon filter/s and recycled into the surrounding environment.
IMPORTANT: Check that air recirculation is ensured.
If the hood does not have the carbon filter/s, order one/them and fit before use.
Install the hood away from very dirty areas, windows, doors and heat sources.
The hood comes with all the materials necessary for installation on the majority of walls/ceilings. However, a qualified technician must ensure that the materials are
suitable according to the type of wall/ceiling.
GB14
.1
.4
.2
.5
.3
Clack!
Clack!
Ok!
Ok!