Recognition Programming - DAITEM SH402AX Notice D'installation

3. Position the power pack on the
guide rails.
4. Slide the power pack downwards
until it is locked into place.
5. guarantee sticker
Remove the pre-cut part of the sticker and stick it to the guarantee certificate in the
user manual supplied with the control panel. If you are adding the siren to an existing
system, use the guarantee sticker provided with this product.
To remove the lithium power pack, press on the unlocking key and slide the pack
upwards.
iMPoRtAnt
• When the siren is powered, it will issue a long beep and automatically switch to installation
mode (tamper mechanism disabled).
• if the siren does not respond as it should: - disconnect the power pack,

3. Recognition programming

Recognition programming allows the siren to be recognised by the control panel.
It must be done with the control panel and siren in installation mode. If they are not in
installation mode, enter:
master code
iMPoRtAnt
• the siren does not need to be placed close to the control panel for recognition programming.
in fact, it is advisable to move it away from the panel (to a distance of at least 2 m).
• the control panel gives the siren a n° during recognition programming.
Locking key
- wait for 2 minutes,
- reconnect the lithium power pack,
- check the siren issues a long beep as it should.
then
SH402AX
A12260A0963C
SH402AX
Coller sur certif
A12260A0963C
installer code
95
SH402AX
A12260A0963C
SH402AX
Coller sur certif
A12260A0963C
GB