Switching On Gas Burners - THOMSON GKT440SI Série Guide D'installation Et D'utilisation

2 / USING YOUR APPLIANCE
• •

SWITCHING ON GAS BURNERS

Each burner is supplied by a tap which can be
opened by pressing it an turning it in a
counterclockwise motion.
●
The point " " corresponds to a closed tap.
— — Choose the desired burner by using the
symbols located near the knobs (e.g. : front
left burner ).
Your hob is fitted with a burner-lighting
system built into the knobs.
To light a burner :
— — Press on the knob and turn it in a
counterclockwise direction
maximum setting
— — Continue to press on the knob to produce a
series of sparks until the burner lights.
The setting for more moderate flame
intensities is between the symbol
symbol .
to the
.
and the
Fig. 01
Warning
— Hold the knob completely pressed
down for a few seconds after the flame
appears to trigger the safety system.
Tip
When a knob becomes difficult to turn,
do not force it. Request an emergency
service call for the installer.
If the flame goes out accidentally, reignite
normally following the starter instructions.
38