Sony SU-WL11 Mode D'emploi page 8

Step 5:
Attach brackets B, C,
D, and E to the TV
Be sure to see the Leaflet (Installing the
Wall-Mount Bracket to the TV) supplied
with the TV.
Attach bracket B to the TV.
1
Using the four screws removed in
Step 4 (page 7), secure bracket B
to the TV firmly.
Rear of the TV
Note
To secure bracket B to the TV, use the
screws removed from the tabletop
stand, not the ones from the hinge
cover.
Connect the cables.
2
How to connect/bundle the cables
differs depending on the TV model.
For details, refer to the Operating
instructions of the TV.
Attach bracket C of the desired
3
angle to bracket B.
To prevent damaging the surface of the
rear cover of the TV, put a soft mat on
the rear cover.
Insert the hooked part of bracket
C into bracket B as shown in the
following illustration. Confirm
that both sides of bracket C are
outside bracket B, and secure
them firmly with two of the
supplied screws.
There are three types of bracket C,
each with a different angle: 0°, 5°,
and 10°. Choose the bracket C
with the desired angle to attach.
8
Bracket B
The illustration below shows an
example of how to attach bracket
C with an angle of 0°.
Bracket C
Attach bracket D to bracket C,
4
and secure them firmly with two
of the supplied screws.
Place bracket D onto bracket C as
illustrated below, and secure them
with the two screws.
Bracket D
Attach bracket E to bracket C,
5
and secure them firmly with two
of the supplied screws.
Slide the shaft of bracket E into the
notches of bracket C as illustrated
below. Secure them with two screws,
one on each side. When you have
attached bracket E, remove the soft
mat from the rear cover of the TV.
Note
Be careful not to get your fingers
caught between the brackets when
attaching them.
The angle "0°," "5°," or
"10°" is marked on the
side of bracket C.
Bracket E
Shaft