Sony VPLL-3007 Mode D'emploi page 8

Replacing the
Projection Lens
Notes
• Be careful not to drop the projection lens.
• Avoid touching the lens surface.
• Lenses can be scratched easily. When
handling lenses, always place them gently on
a stable, level surface in a horizontal
position.
• The illustration of VPL-FHZ65 is used for
the explanations.
Removing
1
Return the projection lens to the center
position.
While the projector is turned on, press
the LENS SHIFT button on the Remote
Commander, then press the RESET
button on it. The projection lens returns
to the center position.
Note
The projection lens cannot be removed
unless it has returned to the center position.
2
Turn off the projector, then unplug the
AC power cord from the wall outlet.
Caution
When replacing the lens, your eyes may
be damaged if a strong light accidently
gets into your eyes. Before replacing the
lens, turn off the projector and then
unplug the AC power cord.
3
While pressing and holding down the
LENS RELEASE button, rotate the
projection lens counterclockwise to
pull out the lens straight.
8
GB
Replacing the Projection Lens
LENS RELEASE
Projection lens
button
Note
For the location of the LENS RELEASE
button, refer to the Operating Instructions of
the projector. The location of the button is
different depending on the model.
Attaching
1
Fully insert the projection lens with
the index on the lens facing toward the
top surface of the projector.
Top of surface of the projector
2
Rotate the lens clockwise until it
clicks.
Note
When attaching the projection lens, do not
press the LENS RELEASE button.
Index