Philips HB 812 Mode D'emploi page 9

Solarium does not operate as required?
If the solarium should not operate as required, this may be due to a defect. In this case do not hesitate to apply to your dealer or
to a Philips Service Centre.
However, it is also possible that the appliance has not been installed according to the instructions or is used incorrectly.
If this is the case, you will be able to solve the problem immediately.
You may check the following section before contacting your dealer or Philips Service Centre.
Problem
• Solarium does not switch on.
• The power fuse switches the mains power off when
switching on or while using the solarium.
• The browning is not according to your expectations.
Possible cause
- Appliance is not positioned correctly for use.
- Mains plug is not in wall socket.
- No mains power. (Please check with other appliance.)
- The lamps are still too warm to restart. (Allow the lamps to
cool down for approx. 3 minutes.)
- Ventilation was insufficient and the automatic thermal
safety device has switched the appliance off. Remove the
cause of overheating (e.g. take towel away from
ventilation opening) and wait for 10 minutes before
switching on again.
- Check the fuse to which the solarium has been connected.
The proper type for your solarium is a 13 A or 16 A normal
fuse or a slow reacting automatic fuse.
- You followed a course which is not the most appropriate
for your skin type.
- The operational distance is larger than indicated.
- After using for a long time the UV production of the lamps
decreases. (With normal use this will not be noticeable for
years.) You may compensate for this effect by selecting
longer treatment times or have the sun lamps replaced.
- You use an extension cord which is too long and/or does
not allow the required power levels. In general, we advise
not to use an extension cord. Please apply to your dealer.
9