Texas HS600TG Manuel D'utilisation page 13

1.
Remove the lock pin
2.
Lift the front of the machine to free the brush and pull the supporting wheels out.
3.
Remove or add the spacer ring (1 ring = approx. 5 mm)
4.
Install support wheels, remove / add spacer ring, fasten with locking pin.
Angle adjustment of brush
The brush can be pivoted 20 degrees to either side. This is done by pushing the swing handle
down, turning the brush and releases the handle so the detent clicks into place.
The swing handle is shown on Figure 2, item L
Height adjustment of handle
Adjust the handle such that the working height is comfortable. Use the hand wheels on each side
of the handle bar.
Figure 3, C.
Technical specifications
Model
Total width (mm)
Working width (mm)
Weight w/o fuel (kg)
Brush diameter (mm)
Swinging brush (positions)
Speed (km/h)
Tire size
Tire pressure (psi)
Troubleshooting
Problem
The engine won't start:
The engine runs unevenly:
If the brush will not run:
If the machine will not run:
If the machine does not sweep effectively:
(Hint: Complete a wheel at a time)
HS600TG
3.00 x 10
Solution
1. Check sparkplug.
2. Check that the spark plug cap is fitted correctly.
3. Check if the motor is equipped with an ignition switch.
(It must be activated)
4. Check if the motor is equipped with a fuel valve.
(It must be activated)
1. Check that the choke has been released.
2. Check fuel for impurities.
1. Check that the clutch is adjusted correctly.
2. Check that the belt is tight.
1. Check that the clutch is adjusted correctly.
2. Check the belt.
1. Check the distance between the brush and working surface.
13
HS600B
650 650
600 600
66 66
350 350
3 3
3 3
3.00 x 10
30 30
HS600TGE
650
600
67
350
3
3
3.00 x 10
30