yeedi K652G Manuel D'instructions page 24

No. Scenario
Robot cannot return to
3
the Docking Station�
Robot misses cleaning
spots to be cleaned,
4
or repeats cleaning the
area cleaned�
Robot gets stuck while
5
working and stops�
Robot is making too
6 much noise when
cleaning�
24
EN
Possible Cause
The Docking Station is not correctly placed�
The Docking Station is not correctly connected�
The Docking Station is manually moved during the
cleaning�
Robot did not start cleaning from the Docking
Station�
The cleaning cycle is interfered by small objects or
barriers on the floor�
Robot is working on slippery polished floors�
Robot is unable to reach certain areas blocked by
furniture or barriers�
Robot gets stuck while working and stops�
Robot might be stuck under furniture with an
entrance of similar height�
Robot is tangled or blocked with debris�
Solution
Refer to Section 3�2 correctly place the Docking
Station�
Make sure the Docking Station is correctly connected�
It is suggested not to move the Docking Station during
the cleaning�
Make sure Robot starts cleaning from the Docking
Station�
Remove power cords and small objects from the floor
to ensure cleaning efficiency� Robot will automatically
clean the area missed, please avoid moving Robot
manually or block the path during the cleaning cycle�
Make sure the floor wax is dried before Robot starts
cleaning�
Tidy up the area to be cleaned by putting furniture and
small objects in their proper place�
Robot will try various ways to free itself� If it is
unsuccessful, manually remove the obstacles and
restart�
Please set a physical barrier�
Clean Robot as described in section Maintenance and
restart� If the trouble persists, please contact Customer
Care�