Audiophony PA PREZONE88 Guide De L'utilisateur page 13

MX82 - Mixer/Préampli multizone rackable avec 8 entrées et 2 sorties
16
BGM LEDs
These LEDs indicate a signal for each input.
17
6
System mode LEDs
When you cascade several PREZONE88, you must
declare the mode of each device, the first one always
being MASTER. In the following paragraph you will find
more details about the declaration of each mode.
REAR PANNEL
3 2
14
5 15
1
Alarm connectors
These connectors, when connected to smoke detectors,
automatically trigger the warning message recorded on
the area concerned in the event of smoke detection.
2
SYSTEM MODE Dipswitches
These dipswitches allow you to choose in which mode
the PREZONE88 will operate.
The positions of the dipswitches corresponding to each
mode are given below:
- : Mode MASTER
- : Mode SLAVE 1
- : Mode SLAVE 2
- : Mode SLAVE 3
7
1 4 7
16
18
Power ON switch
8
6 8
13 10
3
DC24V connectors
The PREZONE88 is likely to be installed in a public place
and act as an audible warning centre in the event of an
emergency. To prevent it from no longer being powered
in the event of a mains failure, it is equipped with a 24V
emergency power supply input.
4
SYSTEM MUTE connector
This connector allows to connect a dry contact switch in
order to remotely disconnect all zones.
5
Power supply input
Connect the supplied IEC cable to this input and connect
it to the mains after checking the voltage supplied.
6
REMOTE MIC inputs
These RJ45 inputs are used to connect the MIC-DESK8M
or MIC-DESK16M announcement microphones.
With MIC-DESK, you can select each zone individually
on which announcements will be broadcast.
7
LEVEL REMOTE MIC potentiometers
These potentiometers are used to adjust the input level
of the announcement microphones.
16 9
9
11
17
Français
18
12
Page 13