Troubleshooting - RIDGID RP 200-B Mode D'emploi

Troubleshooting

SYMPTOM
Tool will not turn ON
when switch is pressed.
Tool turns OFF either
when switch is
depressed or in the
middle of a press cycle.
The LED light will contin-
uously flash ON and
OFF.
The LED light flashes two
times then pauses con-
tinuously. (The tool will
not run when the switch
is pressed.)
The LED light flashes
three times then pauses
continuously as long as
tool is turned ON and
tool functions properly.
LED light flashes three
times then pauses con-
tinuously, and tool will
not begin press cycle
when switch is
depressed.
Jaws are locked onto
fitting.
The pressed connections
produced are not com-
plete.
POSSIBLE REASONS
Battery is completely discharged or battery has
failed.
Battery not properly inserted into handle of tool.
Battery is too low.
Tool or battery is too cold or too hot.
Scheduled maintenance/recalibration is required
after 30,000 presses.
Scheduled maintenance/recalibration is manda-
tory after 32,000 presses, or tool malfunction
detected. Tool is "locked" and will not function
until tool is serviced.
Press was not successfully completed.
Used wrong jaws for the tube size or material.
The tool was not square to the tube.
Jaw contour was not aligned with the fitting contour.
Tool is in need of repair.
RP 200-B Press Tool
SOLUTION
Insert fully charged battery/recharge dead battery.
Check to assure battery is fully inserted.
Insert fully charged battery/recharge dead battery.
Bring tool and battery to correct operating range
between 15°F (-10°C) to 122°F (50°C) by allow-
ing the tool to sit in a conditioned room.
NOTE! Fitting must be repressed if tool stops
in the middle of a press cycle. Failure
to do so may result in a leaking fitting.
Contact RIDGID Technical Service Department at
(800) 519-3456 for nearest Authorized Press Tool
Service center.
Contact RIDGID Technical Service Department at
(800) 519-3456 for nearest Authorized Press Tool
Service center.
Push pressure release valve to remove jaws from fit-
ting. Inspect and repress fitting.
Install the correct jaws.
Redo the joint with new fitting and new tube.
Make sure that the tool is square to the tube.
Redo the joint with new tube and new fitting.
Make sure the jaw contour is aligned with the
fitting contour.
Contact RIDGID Technical Service De partment at
(800) 519-3456 for nearest Authorized Press Tool
Service center.
11