Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

USAGE

The hood is fitted with a control box
behind the opening, containing 3
controlside (fig.1).
- Slide "L" is used to switch the lighting on
and off.
- Slide "M" is used to start or stop the fan,
confirmed by a power on indicator.
- Slide "V" is used to select the extraction
power from "1" to "3".
A contactor above the control box cuts
off the power as soon as the auvent is
fully closed, but functions previously
regulated with the slides are maintained.

MAINTENANCE

Before carrying out any work (cleaning -
changing filters - lighting), switch the
appliance off by pulling the plug out if you
can reach it, or by switching the circuit
breaker off.
Grease filter
The metal grease filter should be cleaned
every two months with normal usage and
can be cleaned in a dishwasher or by
hand using a mild detergent or liquid
soap.
Proceed as follows: (see fig.2 - fig.3)
- Open the auvent to the end stop.
- Remove the filters one at a time,
pushing the handle towards the rear
of the hood.
When replacing, ensure that the
handle faces outwards.
NOTE: new grease filters can be
obtained from your dealer.
Active carbon filters
(on appliance used in recycling version).
- Air drawn in also passes through the active carbon filter designed to eliminate cooking
odors.
- This filter cannot be cleaned, and therefore must be replaced at a frequency which
depends on the frequency of use (about twice per year).
106_01FA
1
2
106_03FA
3
5

Publicité

Table des Matières
loading

Table des Matières