Rechargeable Batteries - Teac R-1 Manuel Du Propriétaire

The R-1 uses a Nickel-Metal-Hydride battery
pack stored in the battery compartment.
Leaving the AC adaptor connected to the R-
1 and plugged in AC line, even when not in
use, ensures the batteries will be fully
charged when you need to use the R-1 on
battery power. The R-1 can be used for 6 to
7 hours after batteries are fully charged.
< When the batteries become discharged
and need to be recharged, the POWER
ON indicator blinks at intervals. And the
blinling will grow faster as the batteries
get closer to discharge until the R-1 shuts
off automatically to protect the batteries.
< When the R-1 is not used but the AC
adaptor plugged in, the batteries will be
completely charged within approximately
3.5 hours from full discharge. During this
period the POWER ON indicator flushes at
intervals.
< When the R-1 is ON and the AC adaptor
plugged in, the batteries will be
completely charged within approximately
24 hours.
< It may take up to 4 charge and discharge
cycles before the batteries are operating
at full capacity when the R-1 is new or
left unused for several weeks.
It is suggested that the R-1 is plugged in
for about 12 hours before you use it first.
< Once the R-1 has been fully charged
while it is OFF, do not unplug the AC
adaptor and then immediately plug it
again, as this will restart the charging
even though the batteries are fully
charged. Doing this repeatedly will
damage the batteries.
< If the R-1 is not plugged in, the batteries
will slowly self-discharge as a safety
measure.

Rechargeable Batteries

Battery Replacement
Caution:
When the batteries are exhausted, replace
the battery pack with new one.
1. Remove the battery compartment cover.
2. Disconnect the connector of the battery
pack, and remove it.
3. Insert a new battery pack and connect its
connector.
4. Close the cover.
< Do not heat or disassemble rechargeable
batteries and never dispose of old
batteries by throwing them in a fire
5