Operating Instruction - Electrolux EXD16DN4W Manuel D'utilisation

8 www.electrolux.com

4. OPERATING INSTRUCTION

4.1 Connect the Unit to Power
Allow the unit to reach room temperature
before operating.
Unit must be upright for one hour prior to
operating.
To begin operating the dehumidifier,
follow these steps:
1. Plug the power cord into a properly
grounded 220-240V AC outlet.
2. If the BUCKET FULL light is on,
Remove and empty the bucket and re-
install to reset the float switch.
4.2 To Run in Continuous Mode
1. Press the ON/OFF button.
2. Pressing the mode button until the
cont indicator light.
4.3 To Set Desired Humidity
After a few days when the Relative
Humidity has declined, press the
HUMIDITY
a value between 35% to 85%, so the
room is kept at a comfortable humidity.
Pressing the
the humidity selection in 5% increments.
After you have set the desired humidity,
the readout will display the actual room
humidity.
4.4 Change the Fan Speed
You can use the fan button
the fan speed to low, med and hi. In
the high fan speed, both the indicators
which above the low and med will light.
A higher fan speed will result in quicker
moisture removal.
or buttons to choose
or buttons will change
to change
4.5 SMD mode
At smart dehumidifying mode, the unit
will automatically control room humidity in
a comfortable range 45%~55% according
to the room temperature. The humidity
setting function will be invalid. To activate
the SMD mode, press the mode button
until the SMD indicator light.
During the SMD mode the humidity
is controlled by the unit automatically,
no need to change the setting humidity
manually.
4.6 Dryer Mode
The unit can reach the MAX
dehumidification performance when
it is under the Dryer mode. The fan
speed is fixed at high fan speed. The
humidity level is automatically controlled
according to the actual room humidity.
To activate the Dryer mode, press
the mode button
indicator light.
30~50cm
30~50cm
1)
1) Air flow direction;
until the Dryer
2)
2) Wet clothes.