Fundamental Safety Information; Observe The Information In The Operating Instructions; Staff Training; Transport And Storage - KERN&SOHN CM Série Mode D'emploi

4 Fundamental safety information

4.1

Observe the information in the operating instructions

Please read the operating instructions carefully before erecting and commissioning,
even if you already have experience with KERN balances.
4.2

Staff training

The device may only be operated and looked after by trained members of staff.

5 Transport and storage

5.1

Acceptance check

Please check the packaging immediately upon delivery and the device during un-
packing for any visible signs of external damage.
5.2

Packaging

Please retain all parts of the original packaging in case it should be necessary to re-
turn items at any time.
Only the original packaging should be used for return consignments.

6 Unpacking, installation and commissioning

6.1 Place of installation, place of use

The balance is constructed in such a way that reliable weighing results can be
achieved under normal application conditions.
By selecting the correct location for your balance, you will be able to work quickly and
precisely.
Therefore please observe the following at the place of installation:
• Place the balance on a firm, level surface;
• Avoid extreme heat as well as temperature fluctuation caused by installing
next to a radiator or in the direct sunlight;
• Protect the balance against direct draughts due to open windows and doors;
• Avoid jarring during weighing;
• Protect the balance against high humidity, vapours and dust;
• Do not expose the device to extreme dampness for longer periods of time. In-
admissible bedewing (condensation of air moisture on the device) can occur if
a cold device is taken into a significantly warmer environment. In this case,
please acclimatise the device for approx. 2 hours at room temperature after it
has been disconnected from the mains.
• Avoid static charging of the material to be weighed, weighing container and
windshield.
6
CM-BA-e-0618