Publicité
Les langues disponibles
Les langues disponibles
USER GUIDE
the direction keys key to select this item. Then you can do below:
DELETE HANDSET
This function allows the user to delete a handset registered from the base.
Press SET/OK key, the first show is DELETE HS
Press SET/OK key to enter, the user will be prompted to enter the PIN code.
Input the correct 4-digit pin code using digit key (the default PIN code is 0000) and press
SET/OK key to confirm.
Press the direction keys, will scroll the handset label list up and down (if have multi-
handsets registered).
Press SET/OK key to confirm. The delete handset will be deleted from the list on
registered handset on the base, and the handset will behave according to the out of
range condition.
*After you delete the handset, you will can't enter base settings menu in idle mode by
using the handset.
DIAL MODE
The user can select to change the mode will dial.
Press SET/OK key, then using the direction keys to select DIAL MODE item.
Press SET/OK key to enter.
Press the direction keys to select the TONE and PULSE dial mode.
Press SET/OK key to confirm your selection.
Note: According to your telephone lines or PABX systems you may need to change the dialing
mode between Tone and Pulse.
FLASH TIME
The user can select the flash time (100ms, 300ms, 600ms and 1000ms) to meet your telephone
line or PABX requirement.
Press SET/OK key, then using the direction keys to select FLASH TIME item.
Press SET/OK key to enter.
Press the direction keys to select the 100ms, 300ms, 600ms and 1000 ms.
Press SET/OK key to confirm your selection.
MODIFY PIN
Some functions (including handset delete and base default) require a PIN code. The default PIN
is 0000, but you are able to change to your personal 4-digit PIN.
Press SET/OK key, then using the direction keys key to select MODIFY PIN item.
Press SET/OK key to confirm.
Entry the existing PIN code by using numerical keys (the default PIN code is 0000), then
press SET/OK to confirm.
If the old code is validated. The user will be prompted to enter a new PIN code.
Once a new PIN code has been entered, press SET/OK to confirm, the user will be
requested to repeat to input the new PIN code.
Input the new PIN code again, press SET/OK to confirm.
BASE DEFAULT
This function allows the user to restore the base setting to the factory default.
ITCOMBO100
39
EN
Publicité
