Adjusting The Angle - Selegiochi STAR THEATRE Mode D'emploi

ENGLISH
1. Place the projector 2. Connect one end
on a fl at, stable surfa- of the adaptor to
ce such as a table. the projector and
(The ideal projection the other end to the
distance is between power supply.
2 and 2.30 metres.)
If the centre of the projected image is out of focus, turn the plastic ring of the focus adjustment.
The stars on the edge may appear to be more out of focus than those at the centre. This diff e-
rence is due to the lens structure and does not indicate that the projector is faulty.
1. Loosen the
screws on both
sides of the
projector.
Do not try to change the angle without loosening the screws and do not tighten them excessively.
1. Turn the projector off by
turning the switch to OFF.
Changing the disc when the projector is turned on can cause eye injuries. To avoid this danger, the projector turns itself
off automatically.
It is advisable to insert and remove the disc when the room is lit and not when the projector is the only light source, one
reason being that the projector must be turned off each time a disc is inserted or removed.
USING THE SHOOTING STARS FUNCTION
Remember that a shooting star will be seen approximately every 30 seconds, always in the same place.
1. Turn the Shoo-
ting Stars function
switch on the front
of the projector to
ON. The SS pilot
light will come on.
22
INSTRUCTIONS FOR USE
3. Open the disc box
using the pull tab, in-
sert the disc so that the
logo SEGA TOYS 2005
is not reversed and clo-
se the box manually.
FOCUSING

ADJUSTING THE ANGLE

2. Lift the
central body
of the projec-
tor and adjust
the angle of
p r o j e c t i o n .
INSERTING THE DISC
2. Open the box and re-
move the disc.
5. Then press the
Rotation function
button to ON (the
Shooting Stars
function only
activates when
the Rotation fun-
ction is on).
4. Remove the lens
cap.
3. Tighten the
screws on both
sides again.
3. Insert the new disc and
close the box.
3. As the image of the
sky turns, the shoo-
ting stars appear. If
you turn the Shooting
Stars function button
to OFF, the function will
be deactivated and the
pilot light will turn off .
5. Turn the projector
on. The pilot light
will light up. When
the room is dark, the
stars will be visible.
4. Turn the projector on by
turning the switch to ON.