Adjusting The Stand; Rotating The Screen; Ergonomic Guidelines - Gateway FHD2400H Manuel De L'utilisateur

Adjusting the stand

Rotating the screen

for more clearance between the speaker bar and the tabletop.
You can rotate the screen clockwise 90° to change between landscape and portrait views. For
information on automatically rotating the display image as you manually rotate the monitor, see
"Using landscape and portrait modes" on page
within a 160° angle of the screen. When the display is rotated to portrait mode, the
side-to-side viewing angle may be reduced.

Ergonomic guidelines

The recommended screen positioning is based upon the following guidelines. These guidelines are
based on available scientific literature and published standards.
Screen height
The recommended screen height for displays (except in special circumstances, such as for bifocal
use) is that the top of the display should be set at or slightly below (about 1 inch or 25 mm) your
eye level while you are sitting in a comfortable working posture. This guideline places the center
of the screen at an ideal 15° to 20° viewing angle for most desktop displays. If the display has
multiple users, the screen height should be easily adjustable to accommodate each user's height
and preference.
Screen tilt
The screen should be tilted so your line of sight is perpendicular to the screen. This angle creates
the most consistent viewing distance when scanning from the top of the screen to the bottom.
You may need to adjust lighting to avoid screen glare when the screen is tilted upward.
8
Using Your Gateway Flat-Panel Monitor
Tip
To rotate the screen while the optional speaker bar is attached, first tilt the screen back
Landscape mode
Tip
For the brightest viewing angle, adjust the screen so that you are viewing it from
17.
Portrait mode