Gateway FHD2400H Manuel De L'utilisateur page 10

4
5
To remove the speaker bar:
1
2
6
Using Your Gateway Flat-Panel Monitor
Plug the speaker bar's power and audio plugs into the appropriate connectors underneath
the monitor.
Power Audio jack
connector
Plug the speaker bar's pink and green 3.5 audio plugs into the appropriate speaker and
microphone connectors on the computer.
Important
For best audio performance, if your video connection uses HDMI, the digital
audio is also conveyed along the same cable, and no additional audio connection is
required. You may need to set your video source's audio mode to
to hear the audio. See your source device's user guide for more information.
For information on using the speaker bar, see
Disconnect all audio and power cables from the speaker bar.
Press the two clips on the back of your monitor, then slide the speaker bar back.
Mounting clip
PCM or ANALOG
"Using the speaker bar" on page 18.