THOMSON CT500BT Mode D'emploi page 17

3) Press the SKIP+ or SKIP-button to set the DESIRED ALARM1 MINUTE, then press the ALARM
SET/FUNCTION button to confirm.
4) Press the SKIP+ or SKIP-button to set the DESIRED ALARM1 SOURCE (buzz or radio), then
press the ALARM SET/FUNCTION button to confirm.
5) Press the SKIP+or SKIP- button to set the DESIRED ALARM2 HOUR, then press the ALARM
SET/FUNCTION Button again.
6) Press the SKIP+ or SKIP-button to set the DESIRED ALARM2 MINUTE, then press the ALARM
SET/FUNCTION button to confirm.
7) Press the SKIP+ or SKIP-button to set the DESIRED ALARM2 SOURCE (buzz or radio), then
press the ALARM SET/FUNCTION button to confirm.
NOTE: In standby mode, press the ALARM SET/FUNCTION button to turn the alarm1 & alarm2
function on/off. The "Alarm 1" & "Alarm 2" icon will show on the LED display once the alarm function
is active.
SHUT OFF THE ALARM
1) When the alarm goes off, press the STANDBY/TIME SET BUTTON to turn off the alarm. The alarm
will reset for the next day.
2) To turn off the alarm completely (not reset for the next day), press the ALARM SET/FUNCTION
button repeatedly until "Alarm 1" & "Alarm 2" icon are off.
SNOOZE FUNCTION
When the alarm activates, press the PLAY/PAUSE/SNOOZE BUTTON. The alarm will turn off and will
ring again 9 minutes later.
DIMMER FUNCTION
Press the DIMMER button to select your desired display brightness.
VOLUME CONTROL
a) Press the VOL+ button to increase the volume
b) Press the VOL- button to decrease the volume.
RADIO OPERATION
1) Press the STANDBY/TIME SET BUTTON to turn on the unit first
2) Press the ALARM SET/FUNCTON BUTTON repeatedly until the frequency is shown on the display
How to use the buttons for radio
i. Manual Tuning
Press the SKIP- or SKIP+ button to search for the desired frequency.
ii Automatic Tuning
a) Press & hold the SKIP-or SKIP+ button until the display frequency starts running
b) When a station of sufficient strength is found Tuning will stop or you can stop automatic tuning
by pressing the SKIP- or SKIP+ button.
3) To turn off the radio, press the STANDBY/TIME SET BUTTON.
Note:
The FM wire antenna should be fully extended for better FM reception.
MANUAL PRESETTING
1) Tune into the desired radio station as shown above.
2) Press and hold the STOP button for 3 seconds; "P 01" will blink on the display. Press the SKIP- or
SKIP+ button to select the program number (01-10) you want it stored to. Then press the STOP
button again to store it.
3) Repeat the same procedure until all the desired radio stations are stored into the program list.
MEMORY RECALL
Recall the stored frequencies by pressing the STOP button first , then press the SKIP- or SKIP+ button
to select station 1 to 10 as desired.
Play from Bluetooth-enabled devices
With this product, you can listen to audio from Bluetooth-enabled devices.
- EN 6 -