Potential Malfunctions And Their Elimination; Conditions Of Storage, Transportation And Operation - Agu Sunny SUN1 Mode D'emploi

10

POTENTIAL MALFUNCTIONS AND THEIR ELIMINATION

If there is a problem with the device while the device is operating, first refer to this
list of possible malfunctions.
Table of malfunctions and ways of their elimination
Problem
The lamp
does not illuminate
The lamp is not
controlled through
the application
The alarm does
not work at the
set time
CONDITIONS OF STORAGE, TRANSPORTATION
11
AND OPERATION
• The device should be transported at –10 °C to +40 °C with a maximum
relative humidity of 75 % or less.
• The Smart Natural Light Lamp AGU SUN1 should be operated and
stored at a temperature of +10°C to +30 °C with a maximum relative
humidity of not more than 65 %.
•
Do not subject the device to sudden temperature fluctuations. Do not
expose the device to high humidity.
EN
Possible causes
The lamp tumbler switch is off
The wall switch is switched off
There is no connection with
the power supply network
The phone is out of range of
the wireless lamp module
Wireless communication is
disabled on the phone
During Alarm Setting,
the lamp was disconnected
from the power supply
network or wireless
communication connectivity
was lost
Solution
Switch on the lamp tumbler
Switch on the wall switch
Restore the connection with
the power supply network
Come closer to the device
Turn the wireless
communication on
Do not disconnect the lamp from
the power supply network. For
switching off use the sensor
button or the application.
Always keep wireless connec-
tivity On at smartphone during
alarm setting
41