Agu Sunny SUN1 Mode D'emploi page 39

The first mode of lamp illumination.
When the lamp is turned on for the first time, the night lamp mode is acti-
vated (the lamp power makes 30 % of the «dawn» mode by default). The
«night light» mode may also be set by using the application.
The second mode of lamp illumination.
If the user turns off and then turns on the lamp again for 3 seconds, the
second lamp mode will turn on, in which the lamp power reaches 100 %
(the «daylight» mode).
There are 2 options for switching the lamp illumination modes:
Option 1: when mounting the lamp on the ceiling, you can switch the
modes by using a switch on the wall.
Option 2: when mounting the lamp using the supplied cable, you can
switch modes either by tumbler switch on the cable or using the sensor
button located on the back of one of the lamp beams.
OPERATION OF THE DEVICE USING A MOBILE APPLICATION
NOTE
By downloading the application you will get the following opportunities:
•
control the lamp distantly;
• set the schedule of illumination modes;
• set an alarm;
•
adjust the «nightlight» mode.
Install the application: Android 5.0 and higher, iOS 8.0 and higher.
EN
during 5 seconds
or or
39