Calibrating; Weighing; Cleaning; Fault/Remedy - ADE Victoria BM 701 Mode D'emploi

Calibrating

Calibrating
Before weighing yourself for the first time, you have to calibrate the scales in order to
obtain a weighing result that is as exact as possible.
− Using the calibration wheel, centre the weight pointer on the "0" of the dial.
Check the zero-setting from time to time, e.g. when you change the
location of the scales. When no load is on the scales, the weight pointer
must be centred on "0".

Weighing

1. Position yourself on the scales. Remain standing still and do not hold on to anything.
2. Read off your measured body weight from the weight pointer.
‚ Weigh yourself with as little clothing on as possible.
‚ Try to weigh yourself always at the same time and under consistent
conditions in order to obtain comparable values.

Cleaning

NOTE on material damage
‚ Do not immerse the scales in water or other liquids.
‚ Do not under any circumstances use harsh, scraping, or abrasive
cleaning agents or the like to clean the scales. If you do, the surface
could be scratched.
− Wipe down the scales as needed using a lightly dampened, soft cloth.
− Disinfect the weighing surface from time to time using a suitable disinfecting
agent (available at specialist retailers and pharmacies).

Fault/Remedy

Fault
The scales are showing obviously
false weighing results.
12
Possible Cause
‚ Are the scales standing on a firm, level
surface?
‚ Are the scales correctly calibrated?
(see chapter "Calibrating").
Bathroom Scales BM 701 | BM 708