Teesa TSA5002 Manuel D'utilisation page 21

Owner's manual
System) to operate. If the voltage drops below this, the fridge will stop running.
Mount the handle before first use.
• Plug in the power cable. Use the ON/OFF switch to turn on the fridge. The LED display on
the control panel will light up and the interior temperature will be displayed.
• Press SET and then press the UP
lock in the target temperature press set three times or leave for 5 seconds. The screen will
display the current temperature inside the unit after the target temperature is set.
• If the power supply is cut off, the refrigerator will switch off automatically and then
automatically switch on again when the unit receives power.
• To change the units between ºC and ºF, press SET twice and then UP
change the setting.
To change the battery protection mode press the SET button three times and the use the
•
UP or DOWN
to set the displayed setting. The three battery protection modes are as follows:
Power Status of battery
supply protection
Cutting off voltage
DC 12 V
Restarting voltage
HANDLE MOUNTING
USING THE DEVICE
or DOWN
buttons to change between the settings. Leave the unit for 5 seconds
LOW MODE
10.1+/-0.3 V
11.1+/-0.3 V
buttons to adjust the temperature. To
MIDDLE MODE
11.4+/-0.3 V
12.2+/-0.3 V
21
EN
or DOWN to
HIGH MODE
11.8+/-0.3 V
12.6+/-0.3 V