Télécharger Imprimer la page

Makita CL108FD Manuel D'instruction page 4

Masquer les pouces Voir aussi pour CL108FD:

Publicité

Les langues disponibles

Les langues disponibles

Hard pieces with sharp edges, such
as wood chips, metals, stones,
glasses, nails, pins or razors
Powder to clot such as cement
or toner
Conductive dust such as metal
or carbon
Fine particle like concrete dust
Such action may cause fire, injury
and/or property damage.
Stop operation immediately if you
3.
notice anything abnormal.
If you drop or strike the cleaner,
4.
check it carefully for cracks or dam-
age before operation.
Do not bring close to stoves or other
5.
heat sources.
Do not block the intake hole or vent
6.
holes.
SAVE THESE
INSTRUCTIONS.
Symbols
The followings show the symbols used for
tool.
volts
direct current
Important safety
instructions for
battery cartridge
Before using battery cartridge, read
1.
all instructions and cautionary mark-
ings on (1) battery charger, (2) bat-
tery, and (3) product using battery.
Do not disassemble battery
2.
cartridge.
If operating time has become
3.
excessively shorter, stop operating
immediately. It may result in a risk
of overheating, possible burns and
even an explosion.
If electrolyte gets into your eyes,
4.
rinse them out with clear water and
seek medical attention right away. It
may result in loss of your eyesight.
Do not short the battery cartridge:
5.
Do not touch the terminals with
(1)
any conductive material.
Avoid storing battery cartridge
(2)
in a container with other metal
objects such as nails, coins, etc.
Do not expose battery cartridge
(3)
to water or rain.
A battery short can cause a large
current flow, overheating, possible
burns and even a breakdown.
Do not store the tool and battery car-
6.
tridge in locations where the tempera-
ture may reach or exceed 50 °C (122 °F).
Do not incinerate the battery car-
7.
tridge even if it is severely damaged
or is completely worn out. The bat-
tery cartridge can explode in a fire.
Be careful not to drop or strike battery.
8.
Do not use a damaged battery.
9.
The contained lithium-ion batteries
10.
are subject to the Dangerous Goods
Legislation requirements.
For commercial transports e.g. by third
parties, forwarding agents, special
requirement on packaging and labeling
must be observed.
For preparation of the item being
shipped, consulting an expert for haz-
ardous material is required. Please
also observe possibly more detailed
national regulations.
Tape or mask off open contacts and
pack up the battery in such a man-
ner that it cannot move around in the
packaging.
Follow your local regulations relat-
11.
ing to disposal of battery.
Use the batteries only with the prod-
12.
ucts specified by Makita. Installing
the batteries to non-compliant products
may result in a fire, excessive heat,
explosion, or leak of electrolyte.
SAVE THESE
INSTRUCTIONS.
4 ENGLISH

Publicité

loading