Table des Matières
Publicité
A n n e x e 5 M i s e e n m a r c h e r a p i d e
Handheld Remote Control
LED
UP
(Set)
DOWN
STOP
(Override)
Front
Back
Lift system error codes
LED
Status
Continuously on
the control box is activated. This disables all
movement of the lift.
Two blinks
Unit is operational. (after unit is powered
Up LED then goes dark)
Three blinks
EEprom Failure
Four blinks
Motor is not moving. Check troubleshooting
chart.
Five blinks
Low AC line voltage
Six blinks
Cables off drum.
Seven blinks
Safety switch triggered.
The remote control lets you operate
the lift including setting the SHOW
and MAINTENANCE positions from
floor level.
The SET and OVERRIDE buttons
are accessed through the small
black holes in the back of the unit.
A paper clip can be used to activate
these buttons.
The SET and OVERRIDE buttons
are not labeled on the remote
control.
(number of blinks of the LED)
No movement toggle switch on the side of
Remote control functions
Function
Buttons
Initial manual mode
OVERRIDE & UP
End manual mode
OVERRIDE & STOP
Set show position
SET & UP
(only works in manual mode)
Set service position
SET & STOP
(only works in manual mode)
Travel to Service position
OVERRIDE & DOWN
(only works in either the top or
SHOW positions)
In the manual mode, the lift will travel as long as
the UP or DOWN buttons is pressed. As soon as
the button is released, the lift will stop.
In the automatic mode, the UP or DOWN buttons
need to be pressed for ½ second to activate the
lift. When changing directions of the lift from Up
to DOWN and vice versa, you do not need to
stop the lift first. By pressing the appropriate
button, the lift will stop immediately prior to
reversing directions.
Publicité
Table des Matières
