DS Produkte YS-8001-1 Mode D'emploi page 16

EN
– possible button strips or zip fasteners are closed so that the warm air can circulate
better inside,
– the sleeves are not twisted or scrunched up.
Items of clothing which cannot be pulled onto the hanger (e.g. socks, under-
wear etc.) are secured using the clips (5). To do this, simply hook the hook of
the clip on the bottom of the hanger attachment.
4. Use the hook to hang the hanger up in a suitable place, noting the safety instructions
and the notices at the start of this chapter.
5. Insert the mains plug into an easily accessible socket. The control lamp (9) starts to
fl ash blue.
6. Press the On / Off switch (8) once to switch on hot air. The control lamp lights up red.
7. If cold air is to be switched on, press the On / Off switch again. The control lamp
lights up blue.
8. Once the item of clothing is dry, press the On / Off switch until the control lamp fl ashes
blue again. The air circulation is ended and the device is in standby mode.
The device automatically switches to cold-air mode after 3 hours and to stand-
by mode after another 3 hours.
9. Pull the mains plug out of the plug socket and allow the device to cool down.
Drying shoes
1. Attach the shoe hanger attachments (6) to the main unit (3) (see the "Attaching /
Removing Attachments" chapter).
2. Place the plastic cover on the ventilation outlet (7) on the bottom of the main unit. This
will ensure that all the hot or cold air fl ows directly into the shoe hanger attachments.
3. Release the hook for hanging up (1) on the back of the main unit and push it upwards.
4. Pull the shoe hanger attachments out to the length you want.
5. Place the shoes which are to be dried over the shoe hanger attachments. When you
do this, make sure that there is nothing inside the shoes (socks, paper, laces etc.).
6. Use the hook to hang the hanger up in a suitable place, noting the safety instructions
and the notices at the start of this chapter.
7. Insert the mains plug into an easily accessible socket. The control lamp (9) starts to
fl ash blue.
8. Press the On / Off switch (8) once to switch on hot air. The control lamp lights up red.
9. If cold air is to be switched on, press the On / Off switch again. The control lamp
lights up blue.
10. Once the shoes are dry, press the On / Off switch until the control lamp fl ashes blue
again. The air circulation is ended and the device is in standby mode.
The device automatically switches to cold-air mode after 3 hours and to stand-
by mode after another 3 hours.
11. Pull the mains plug out of the plug socket and allow the device to cool down.
16