Configuration; Interlocks; Maintenance - ACTEON Equipment SATELEC Mini LED III Supercharged Manuel D'utilisation

MLED III Supercharged U2
activate in the Menu Fast-Cure and the exposure time of
3 seconds.
Your Mini LED SuperCharged is ready to operate once the
menu and the exposure time has been selected.
Place the light guide as close as possible to the surface
of the material to be polymerized, without touching it
as this may adversely affect the quality of the
polymerization. The use of a transparent strip is
recommended.
The polymerization starts by pushing on the ON/OFF
button. The setting will be confirmed by an audible
signal (beep).
A countdown on the LCD screen shows you how much
time remains.
When the polymerization cycle is completed, the time
that was applied is displayed.
You can press the ON/OFF button at any time to
interrupt the current polymerization cycle.
After 5 minutes without use, the unit goes into standby
mode (low consumption). The green indicator light and
the LCD screen backlighting switch off.
The unit can be taken out of standby mode by simply
pressing one of the three buttons (which will not
activate that function when coming out of standby
mode).
VI – CONFIGURATION
6.1 STARTUP
On startup, the unit performs an automatic test
sequence (auto-check).
The device automatically recalls the settings used for
the previous dental treatment.
6.2 MODES
The Fast, Pulse and Stepped modes are selected using
the left button (fig.2-6) on the handpiece.
6.3 EXPOSURE TIMES
The exposure times are selected by pressing the right
button (fig.2-7).
VII – INTERLOCKS
V5:Mise en page 1 22/02/2010
The Mini LED SuperCharged is equipped with a system
for the detection of possible unit operation anomalies.
7.1 EXCESSIVE TEMPERATURE
During intensive use, an excessive temperature may be
detected and the screen then displays the letters "OH"
(Over Heat), the audible warning (beep) sounds 4 times
and the indicator light (two-color LED) becomes red.
It is then recommended that the user leaves the
handpiece to cool for a few minutes, until the indicator
light becomes green again and the screen once again
displays the selected time cycle.
7.2 BATTERY CHARGE LEVEL
When the LCD screen displays the last remaining round
battery charge indicator, the audible alarm (beep)
sounds twice.
You then have about 500 seconds remaining before the
unit becomes completely discharged. It is then
recommended, if possible, to charge the battery for
further use.
When the battery becomes completely discharged, the
letters "Lb" (Low Battery) are displayed on the screen,
the audible alarm (beep) sounds 4 times and the
indicator light (two-color LED) becomes red.
The user must return the handpiece to its charging base
to recharge the unit's battery (see chapter 4.3
INSTALLATION).
VIII – MAINTENANCE
LED SuperCharged, check that:
- The Mini LED SuperCharged is not on its charging
base.
- The battery has been unscrewed from the
- The charging base has been disconnected from the
11
12:47 Page 11
Before conducting any maintenance on the Mini
handpiece.
AC supply.