ION Video 2 SD Guide D'utilisation page 6

Operation
Recording Video
1. Follow the Setup
you will see a preview of your connected device on your screen.
Note: If no micro SD card is inserted, your screen will show No Card Disk.
2. Press the Record button. The LED will begin flashing red to indicate recording is
active.
3. Press the Record button again to stop recording. The recording LED will stop
flashing and your screen will show Saving File.
Note: After 2 hours and 42 minutes of recording, Video 2 SD will automatically
save the file and start recording to a new file.
Saving Files
1. Use the included mini-USB cable to connect the DC Port on Video 2 SD to an
available USB port on your computer.
2. Press and hold the Record button for 3 seconds to switch Data mode. If
connected to a screen, the screen will show DATA and a USB drive picture.
3. You can now access the micro SD card from your computer as an external drive.
4. Files will be automatically saved to the micro-SD card using default file names.
You can copy these files to your internal hard drive for viewing in standard media
software.
You can also remove the micro SD Card from Video 2 SD and insert it directly into
your computer or a compatible SD card reader.
6
directions. When all connections have been made properly,