Publicité
Les langues disponibles
Les langues disponibles
5. FUNCTIONING / MANIPULATION
a) Installation / Assembly :
- Place the equipment on a stable surface.
- Position the accessories
- A distance of 10 cm from the partition or the wall is considered enough.
- Never place the device near a wall or near a partition made of combustible
materials even if it is very well isolated.
- Caution : the display cooling must not be exposed at the sun.
b) First starting :
First cleaning
Clean the device before the first use. (See 6 Cleaning)
Connection of the device
- Make sure that the voltage and frequency of the electrical system comply with
the values indicated on the nameplate.
- Always check that the electric power supply cable or plug are free of damage.
- Make sure that every control knob is positioned on 0.
- Remove the flange at the bottom left (when facing the display) to pay out the
entire length of the cord and feed it through the square hole then close it before
inserting the plug into the socket.
- Connect the electric power supply cable to a socket with a protection wire.
- The display is now connected.
NB: To connect the display to a socket without any protection wire, or to connect
directly to the electrical system, ask for a qualified electrician to make the
connection.
c) Use of device :
Elements of command and display
Command/Display
Electronic thermostat (n° 1 on picture)
Switch 0/I (n° 2 on picture)
Switch 0/I (n° 3 on picture)
Function
Temperature setting
Light On/Off
On/Off
11
Publicité
