Table des Matières
Publicité
7
13
11
6
11
5
50 cm
2011
1
2
14
Burst for
maintenance-works.
14
Avoid any tributary connection from the main circuit. If absolutely necessary then an short as
possible. Observe DIN 1988 / 1717. Additional heating cable is recommended if installed in
non frost-protected areas or in draughty locations.
Start of operation:
ECU switch in "off" position
1)
2)
Fill water circuit with water
3)
Bleed water circuit, pump and heating unit, over pos.2, pos.5 and pos.13
See to it that by-pass line is closed
and that water circuit runs over heating unit!
4)
remaining air bubbles will automatically escape through pos.7
ECU switch to "winter" position
5)
6) C
irculation pump is switched on.
Heating element switches on automatically after approx. 30 min.
Repeat point 3. ! Attention: when ventilating hot water can escape, too!
7)
Necessary return flow temerature on the ECU control panel. (Recommended 6 - 8 °C)
Delivery scope, ex works
(1) Heating unit 3000 W
(2) circulation pump 230 V
(3) non-return valve for water flow
(4) electronic control unit (ECU)
(5) ventilation screw
(6) pressure relief valve
(7) automatic vent valve
(8) non-return flap with adapter and
mounting for return flow sensor
(9) return flow temperature sensor
Installation
14
~ 230 V
4
10
10
11
9
8
3
18
11
tempered
room
14
14
12
14
17
Not included in scope of delivery
(10) drain cock
(11) lock valve
(12) residual-current device switch 230 V, 0,03 A
(13) shut-off valve for manual ventilation
(14) Insulation material, min. thickness 30 mm
(15) bite protection
(16) SUEVIA Drinking Bowls
(17) flow control Ref. 101.0309
(18) filter
(19) heating cable
(20) Warning device Ref. 101.0308
19
14
14
15
15
16
14
Installation layout
20
°C
20
30
10
40
0
50
14
15
17
Publicité
Table des Matières
