Westfalia Automotive 342099600001 Notice De Montage page 2

SIARR
43 - 16
PREPARATION
* Right side : remove the lashing ring.
* Lower the exhaust pipe.
* Make a cut under the bumper as
shown in diagram 1.
ASSEMBLY
* Without screwing, attach the attachment arms under
the spars at points X using the X fasteners.
* Place the coupling at points V – W of the arms,
then attach it with the V and W fastener units.
FINISHING
* Fasten to the couplings indicated below
in the following order: X – V – W.
* Re position exhaust pipe.
FASTENING KIT
2 off HM10x35 screws
V
2 off DEC10 washers
2 off HM10x35 screws
W
2 off DEC10 washers
2 off HM10 nuts
8 off HM12x30 screws (mini) au pas 125
X
8 off DEC12 washers
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
Affix the sticker in
!
the position
!
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
FICHIER : BUREAU\NOTICEDEMONTAGE\NOTICEWESTFALIA\NOTICE\NDM4316-A - FOLIO NDMANG
Type Type
SI046 Approval No.
Tow-bar for
SUZUKI Grand e24*94/20*00*0076
Vitara (5 doors) long
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
342099600001
Diagram 1
Max. Total Max. Total Max. Verti-
Authori. Weight Towable Weight
cal load
2 070 kg 2 000 kg
Value
D
85 kg 10,50 kN